✦ScienexySCIENCE KNOWLEDGE LIBRARY
General science · SCI-FORM-CIR-003

Equivalent Resistance in Parallel

The reciprocal of the equivalent resistance of ideal resistors connected in parallel equals the sum of the reciprocals of their individual resistances.

\(1/R_{p} = 1/R_{1} + 1/R_{2} + \cdots + 1/R_{n}\)

What this formula means

Definition

The reciprocal of the equivalent resistance of ideal resistors connected in parallel equals the sum of the reciprocals of their individual resistances.

Interpretation

Every parallel branch has the same potential difference, while the total current is the sum of branch currents. Adding a parallel branch lowers the equivalent resistance.

Physical Significance

It is used to simplify parallel networks and calculate current sharing among resistive branches.

Scientific principle

Principle

Kirchhoff's current law and Ohm's law.

Derivation

StepExplanationExpression

1

All parallel resistors share the same potential difference.

V₁ = V₂ = ⋯ = V

2

The total current is the sum of branch currents.

I = I₁ + I₂ + ⋯ + Iₙ

3

Apply Ohm's law to each branch.

I = V/R₁ + V/R₂ + ⋯ + V/Rₙ

4

Factor out V and compare with I = V/Rₚ.

1/Rₚ = 1/R₁ + 1/R₂ + ⋯ + 1/Rₙ

Result

The equivalent parallel resistance is found by adding conductances, then taking the reciprocal.

Variables and their meanings

SymbolMeaningDescription

Rₚ

Parallel equivalent resistance

Single resistance equivalent to the parallel network.

R₁, R₂, …, Rₙ

Branch resistances

Resistances of the individual parallel branches.

V

Common potential difference

Voltage across every branch.

I

Total current

Sum of the currents in all branches.

SI units and conversions

Si Unit

ohm (Ω)

Dimensional Formula

[ML²T⁻³I⁻²]

Unit Explanation

The reciprocal sum has units Ω⁻¹; taking its reciprocal gives ohms.

Unit Conversions

ConversionApplication

1 kΩ = 1000 Ω

Convert kilohms to ohms.

Conductance G = 1/R

Using siemens can simplify parallel-network calculations.

Conditions of use

  • The resistors share the same two electrical nodes.

  • The voltage across each branch is identical.

  • The branch currents add at the junctions.

  • Resistances are evaluated at the operating conditions.

Limitations and assumptions

  • The relation applies to parallel resistors, not arbitrary series-parallel networks without reduction.

  • A zero-resistance branch shorts the ideal network terminals.

  • For AC reactive elements, use complex impedances or admittances.

  • Component tolerances and temperature can alter the actual equivalent value.

Step-by-step worked examples

ProblemGivenSolutionAnswer

Two resistors of 6 Ω and 3 Ω are connected in parallel. Find their equivalent resistance.

  • R₁ = 6 Ω

  • R₂ = 3 Ω

StepExplanationCalculation

1

Write the parallel-resistance equation.

1/Rₚ = 1/R₁ + 1/R₂

2

Substitute the values.

1/Rₚ = 1/6 + 1/3

3

Use a common denominator.

1/Rₚ = 1/6 + 2/6 = 3/6 = 1/2

4

Take the reciprocal.

Rₚ = 2 Ω

The equivalent parallel resistance is 2 Ω, which is less than either branch resistance.

Real-world applications

ApplicationExplanation

Household wiring

Parallel connections allow appliances to operate at the same supply voltage.

Power distribution

Parallel branches share a common voltage while drawing separate currents.

Electronic circuits

Parallel resistor networks set loads and bias conditions.

Redundant systems

Parallel paths can provide alternative current routes, subject to circuit design.

Topics

  • electricity

  • circuits

  • parallel resistors

  • equivalent resistance

  • conductance

  • Electricity & Circuits

Formula Meaning

Definition

The reciprocal of the equivalent resistance of ideal resistors connected in parallel equals the sum of the reciprocals of their individual resistances.

Interpretation

Every parallel branch has the same potential difference, while the total current is the sum of branch currents. Adding a parallel branch lowers the equivalent resistance.

Physical Significance

It is used to simplify parallel networks and calculate current sharing among resistive branches.

Sources and further reading

No source has been supplied for this item yet. Treat the claim as needing editorial verification.

← Back to Formula Hub · Suggest a correction or source