✦ScienexySCIENCE KNOWLEDGE LIBRARY
General science · SCI-FORM-EAR-2270

Actual Evapotranspiration Water-Balance Relation

The actual evapotranspiration water-balance relation estimates the amount of water lost from a defined land or soil control volume through evaporation and plant transpiration. It is obtained by accounting for precipitation, irrigation, groundwater exchange, runoff, drainage, and changes in stored water.

\(ET_{a} = P + I + G_{\mathrm{net}} - R - D - \Delta S\)

What this formula means

The actual evapotranspiration water-balance relation estimates the amount of water lost from a defined land or soil control volume through evaporation and plant transpiration. It is obtained by accounting for precipitation, irrigation, groundwater exchange, runoff, drainage, and changes in stored water.

Scientific principle

Principle

The conservation of mass requires that water entering a defined system must equal water leaving the system plus the change in water stored within it. Actual evapotranspiration can therefore be estimated as the residual of a complete water balance when the other fluxes and storage changes are known.

Derivation

  • 1. Define a control volume, such as a soil profile or root-zone layer, and select a calculation period.

  • 2. Identify water inputs, including precipitation P, irrigation I, and net groundwater inflow G_net.

  • 3. Identify water outputs other than evapotranspiration, including runoff R and deep drainage D.

  • 4. Let ΔS = S_end − S_start represent the change in water stored within the control volume.

  • 5. Apply conservation of mass: P + I + G_net = ETₐ + R + D + ΔS.

  • 6. Rearrange the balance to isolate actual evapotranspiration.

  • 7. The result is ETₐ = P + I + G_net − R − D − ΔS.

Final Result

ETₐ = P + I + G_net − R − D − ΔS

Storage Change Relation

ΔS = S_end − S_start

General Water Balance

Inputs − Outputs = Change in Storage

Interpretation

Actual evapotranspiration is estimated as the water input remaining after accounting for other measured water losses and the change in storage.

Variables and their meanings

SymbolMeaningUnit

ETₐ

Actual evapotranspiration during the selected period

mm or m

P

Precipitation entering the control volume

mm or m

I

Irrigation water entering the control volume

mm or m

G_net

Net groundwater contribution, defined as groundwater inflow minus groundwater outflow

mm or m

R

Surface runoff leaving the control volume

mm or m

D

Deep drainage leaving the control volume

mm or m

ΔS

Change in water stored in the control volume

mm or m

S_end

Water storage at the end of the calculation period

mm or m

S_start

Water storage at the beginning of the calculation period

mm or m

SI units and conversions

Actual Evapotranspiration

mm or m per calculation period

Precipitation

mm or m per calculation period

Irrigation

mm or m per calculation period

Groundwater Exchange

mm or m per calculation period

Runoff

mm or m per calculation period

Deep Drainage

mm or m per calculation period

Storage Change

mm or m

Conditions of use

  • The boundaries of the water-balance control volume must be clearly defined.

  • All input and output terms must refer to the same control volume and calculation period.

  • All water-depth terms must use consistent units.

  • Groundwater exchange must use a consistent sign convention, with net inflow positive.

  • Storage change must be calculated as final storage minus initial storage.

  • All important water inputs and outputs must be measured or estimated sufficiently well.

Limitations and assumptions

  • Actual evapotranspiration is calculated as a residual, so errors in other water-balance terms accumulate in the estimate.

  • Unmeasured groundwater exchange can produce substantial errors.

  • The method does not independently separate evaporation from plant transpiration.

  • The estimate depends on the chosen control-volume depth and time interval.

  • A negative calculated value may indicate measurement error, inconsistent sign conventions, or an incomplete water balance rather than physically negative evapotranspiration.

  • The equation does not directly estimate future evapotranspiration without additional information about water inputs, outputs, and storage.

Step-by-step worked examples

ProblemSolutionAnswer

During a hypothetical monthly water-balance period, precipitation is 120 mm, irrigation is 20 mm, net groundwater inflow is 5 mm, runoff is 15 mm, deep drainage is 25 mm, and soil-water storage increases by 10 mm. Calculate actual evapotranspiration.

  • Given: P = 120 mm.

  • I = 20 mm.

  • G_net = 5 mm.

  • R = 15 mm.

  • D = 25 mm.

  • ΔS = +10 mm.

  • Use: ETₐ = P + I + G_net − R − D − ΔS.

  • ETₐ = 120 + 20 + 5 − 15 − 25 − 10.

  • ETₐ = 145 − 50.

  • ETₐ = 95 mm.

The estimated actual evapotranspiration is 95 mm for the monthly period.

A hypothetical soil-water balance has precipitation of 80 mm, irrigation of 10 mm, net groundwater exchange of −2 mm, runoff of 8 mm, deep drainage of 15 mm, and a storage decrease of 5 mm. Calculate actual evapotranspiration.

  • Given: P = 80 mm.

  • I = 10 mm.

  • G_net = −2 mm.

  • R = 8 mm.

  • D = 15 mm.

  • ΔS = −5 mm because storage decreased.

  • Use: ETₐ = P + I + G_net − R − D − ΔS.

  • ETₐ = 80 + 10 − 2 − 8 − 15 − (−5).

  • ETₐ = 88 − 23 + 5.

  • ETₐ = 70 mm.

The estimated actual evapotranspiration is 70 mm for the selected period.

Real-world applications

  • Agricultural water-balance studies

  • Watershed hydrology

  • Drought and water-stress assessment

  • Soil-water storage analysis

  • Irrigation research

  • Ecosystem water-use estimation

Formula Meaning

The actual evapotranspiration water-balance relation estimates the amount of water lost from a defined land or soil control volume through evaporation and plant transpiration. It is obtained by accounting for precipitation, irrigation, groundwater exchange, runoff, drainage, and changes in stored water.

Sources and further reading

No source has been supplied for this item yet. Treat the claim as needing editorial verification.

← Back to Formula Hub · Suggest a correction or source