Introduction
Electrical power describes the rate at which electrical energy is transferred or converted in a circuit. Several equivalent equations can be used depending on the known quantities.
Concept
Electrical power is the product of voltage and current. For an ohmic resistor, it can also be expressed using resistance and either voltage or current.
Mnemonic
Remember 'Power = Volts × Amps' for the basic equation. For a resistor, remember the companion forms using V squared over R and I squared multiplied by R.
Explanation
The equations are P = VI, P = V²/R and P = I²R. The latter two follow from combining P = VI with Ohm's law. Power is measured in watts.
Step By Step
Identify the known electrical quantities.
Use P = VI when voltage and current are known.
Use P = V²/R when voltage and resistance are known for an ohmic resistor.
Use P = I²R when current and resistance are known for an ohmic resistor.
Substitute the values with consistent units.
Check whether the calculated power is reasonable.
Examples
A device operates at 12 V and draws 2 A. Power = 12 × 2 = 24 W.
A 10 Ω resistor has 20 V across it. Power = 20² ÷ 10 = 40 W.
A 3 Ω resistor carries 4 A. Power = 4² × 3 = 48 W.
Limitations
The V²/R and I²R forms assume a resistive component with an applicable resistance value.
In AC circuits, real power calculations may require power factor and RMS quantities.
Power is a rate of energy transfer, not the total energy consumed.
Common Mistakes
Using voltage squared divided by current.
Forgetting to square voltage or current in the appropriate equation.
Confusing watts with watt-hours.
Applying simple DC power equations incorrectly to complex AC circuits.
Practice
Calculate the power of a 24 V device drawing 3 A.
Find the power dissipated by a 5 Ω resistor carrying 2 A.
Calculate the power across a 12 Ω resistor with 24 V applied.